Setting Idle or resetting on DDEC

[Deep C]

We had the misfortune over in islands of having the ddec hiccup on us. She now has 400 rpm for both low and high idle... Does anyone know what sequence of buttons to push to get the high idle back?

[PacificBlue]

Try this to set the User Idle Speed:

1. Put throttle levers in idle position
2. Press and hold LO IDLE button. The green LO IDLE light will begin to flash within two (2) seconds. Engine speed will start to increase at a slow rate. Speed will slowly cycle between 750rpm and the low idle rpm. The speed will continue to cycle until the button is released.
3. Release the LO IDLE button when the engine reaches the desired normal idle speed. The control system has now learned this speed and will return to it whenever the levers are at idle and the low idle is OFF.

Note - this assumes that the Low Idle Mode is active (on) prior to trying these steps.

Hope this helps

[Deep C]

It may very well be that simple... Thank you good sir...