raymarine e120 seatemp quit

[bobfish21]

e120 w/ 600 watt thruhull airmar triducer, b260 I think. seatemp reading 130deg. anyone know if temp sensor is part of the removeable paddle wheel assembly or do I have to remove the whole xducer? thanks for any suggestions.

[NJPete]

Just to confirm you tried to reset it, change the transducer setting in the DSM (i assume its a DSM 300?)?

[hobie2]

i just had the same thing happen to mine. any help would be great.

[tolock]

I have the same problem, although my temp is reading higher 186. My transducer is older, b256, and I was told it can not be fixed. It was recomended to add a temp only ducer that will attach via a Y cable to the DSM 300. I was also told that it could be connected via nema cables as well. See my post as I am looking for some recomendations on which one to use. I am in the same boat trying to figure out how to get my sea temp back online.

I also did what njpete suggested with no luck.

http://www.sportfishermen.com/board/...re-119759.html

Tom

[Free Spirit]

The problem in most cases is in the airmar transducer. The temp element takes a dump. It is not the dsm that is the problem. On my friend's boat, we did add the transom mt temp unit and it works like a charm. Check and see how old the transducer is. There is a 2 yr warrantee on it and Raymarine may make good if you have the documentation.