Hard Stand to do list

[Andaman Andy]

Thinking about hauling out the boat (43ft Tiara) soon to do the anti-fouling and a couple of other things, does anyone have a "To do list" of other stuff i should be checking whilst it is out?

[Fast Forward]

Have the props reconditioned, check the cutlass bearings and all other hardware that is below the rubrail. Wax the hull.

[clt_capt]

Check your trim tabs, Definitely check the taper on your shafts for crevice corosion while your props are off.

Also a good time to check all of your stopcocks and thru-hulls.

You may also want to check your stuffing boxes - prop shafts and rudder shafts

[JD5652]

If you have packless shaft seals...now's the time to inspect and rebuild if needed.....

[giantfan]

I'm sure it goes without saying but I will say it anyway.

Zincs

[Fish Biz]

It doesn't have to do directly with the boat, but pull all your safety equipment and do a complete inspection, it's easier when the boats on land lay out a tarp and put all your safety gear, so you have it all in front of you. Tim

[Flatdog]

If you were thinking underwater lights now is the time,
also remember to check galvic Isolation connections and rudder posts

[austin ensor]

lots and lots of rod holders!!!!!!!

[Andaman Andy]

Great stuff there guys keep it coming

[fishfighter]

Cutless bearing,Up grade transducers,reseal all underwater thru hulls.Inspection of wheels,rudders and shafts.repitching of wheels if needed.Blister coating if needed.Remove water line stain before painting the bottom.