Can anyone help? Ring-pulls needed....

Otoro · 06-16-2009, 12:26 PM

Hi Everyone,

I recently did some repair work on some cockpit hatches and I need to replace the existing ring-pulls. The problem is that these are a bit older and measure 2 1/4" x 2 1/2" and I cannot find this size ANYWHERE. I have tried several sources online (West marine was one) and even though they have them listed at the same size... they shipped me smaller ones.

Does anyone have a potential source for these? this is a minor thing but it is getting frustrating! Picture attached of the smaller version.

thanks

giantfan · 06-16-2009, 01:02 PM

Is it a Sea Dog product?

If it is I believe Mesco carries Sea Dog hardware.

On The Edge · 06-16-2009, 01:42 PM

Try Jamestown Distributors

http://www.jamestowndistributors.com/userportal/main.do

Not sure about the size but they may have what you are looking for..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-16-2009, 01:02 PM	#2
giantfan I think Admin is going to let me have this space Join Date: Jan 2008 Location: Matawan NJ Posts: 1,517 Credits: 4,777.2 Boat: 34 Pursuit Express Home Port: Keyport	Is it a Sea Dog product? If it is I believe Mesco carries Sea Dog hardware.

06-16-2009, 01:42 PM	#3
On The Edge Stop staring at my Avatar. Join Date: May 2008 Location: Douglas Ma. Posts: 427 Credits: 2,413.7 Boat: 22' Proline WA Home Port: On a trailer, I fish all over the Cape Best Catch: 230 lb Mako Occupation: Tradeshow Exhibit Estimator	Try Jamestown Distributors http://www.jamestowndistributors.com/userportal/main.do Not sure about the size but they may have what you are looking for..