LinkBack URL
About LinkBacks
Another demo.
After installing the rear grips.
Mark where the reelseat will go.
Build Arbors,
use foam arbors, some can use cork arbors, drywall tape, masking tape,
Usually 3 arbors along the seat are fine.
Try to have them positioned where the reelseat ends will be.
and
near the end of seat,
Mix epoxy, Kardol or rodbond is fine.
This rod is a light casting rod, so only 2 arbors were used.
Measure arbors to fit seat snug.
Apply Glue,
Install seat.
Make sure it is lined up with your spine marks.
- Home
- Forum
-
Fishing Reports
- Alabama Fishing Reports
- Alaska Fishing Reports
- Canada Fishing Reports
- California Fishing Reports
- Central America Fishing Reports
- Connecticut Fishing Reports
- Delaware Fishing Reports
- Florida Fishing Reports
- Georgia Fishing Reports
- Hawaii Fishing Reports
- Louisiana Fishing Reports
- Maine Fishing Reports
- Maryland Fishing Reports
- Massachusetts Fishing Reports
- Mississippi Fishing Reports
- Mexico Fishing Reports
- New Hampshire Fishing Reports
- New Jersey Fishing Reports
- New York Fishing Reports
- North Carolina Fishing Reports
- Oregon Fishing Reports
- Rhode Island Fishing Reports
- South Carolina Fishing Reports
- Texas Fishing Reports
- Virginia Fishing Reports
- Washington Fishing Reports
- Directory
- Media
- Resources
- Contact Us
- Advertising
- What's New?
Reply With Quote