Planer Rod Build for Parker

[ElMar2530]

I built up the layers first, then undid the wrap and added epoxy as I re wrapped, let the whole thing dry, then turned it down to fit snugly in the blank. Seems solid to me.

Flatliner may be better qualified to answer the question though.

[FLATLINER]

Not necessarily "wrong", but more effort and time than required. Wrap the mesh tape around, mix your epoxy, take a knife and force the epoxy into the mesh tape, apply liberally and then insert into the ferrule and let it dry.

I think it would be easy to over think this. By creating multiple layers of epoxy, variables are being introduced that could possibly result in failure.

Kevin

[ElMar2530]

First rod using ProKote and gotta say, I like it. The extended working time allows it to flow and purge air bubbles better but the low viscosity caused me to get more air bubbles when I was mixing, need to be more careful next time.

Second coat is spinning as I type, check the pics. It should level out a little better in an hour or so.